About YardCalculator
Last updated:
YardCalculator is a free set of calculators for landscaping and construction materials: dirt, topsoil, mulch, gravel, stone, sand, sod, pavers, asphalt and concrete. It turns the measurements of a project into the units suppliers sell in, which are cubic yards, tons, bags and truckloads.
Who runs YardCalculator
YardCalculator.net is run by Usama Iqbal.
Usama Iqbal builds and maintains the calculators, writes and reviews the pages, and is responsible for every number on the site. The site does not claim construction, landscaping or engineering credentials or job-site experience. Its value comes from careful math and published sources, both of which are shown on every page so you can check them.
Why this site exists
Ordering bulk material is easy to get wrong. A depth measured in feet instead of inches makes an order twelve times too big. A supplier that sells by the ton and another that sells by the yard are hard to compare. Bag sizes, truck sizes and material weights vary, and many calculators online give a single answer with no explanation of where it came from.
YardCalculator was built to fix that in three ways:
- Answers in the units you order in. Every calculator gives cubic yards and, where it makes sense, tons, bags and truckloads.
- The math is shown. Each page has a “How we calculate” box with the formula and the values behind it.
- Every real-world number is sourced. Weights, bag yields, recommended depths, truck sizes and prices link to the page they came from.
How the calculators are built
Every formula on the site lives in one shared calculation engine. The calculators and the numbers in the articles both use it, so a page and its calculator can never disagree. The engine converts everything to feet first, then to cubic feet, cubic yards, tons, bags and truckloads.
The engine is covered by automated tests that check typical inputs, edge cases such as zero or negative values, unit conversions and rounding. Quantities you order by the piece, such as bags and truckloads, are always rounded up. The build fails if any engine line is left untested.
How the numbers are checked
Every formula is unit-tested and every material value is checked against manufacturer data, university extension guides and industry sources, which are listed on each page. In detail:
- Two sources for defaults. A value a calculator starts with, such as the weight of a cubic yard of gravel or the depth of mulch, needs two independent sources that agree. If sources disagree, the site shows the range instead of picking one number.
- Exact wording kept. For each source the site stores the exact sentence or table row that states the value, the page address and the date it was read. A test confirms the published number appears in that wording.
- No numbers from memory. If a value cannot be verified, it becomes a field you fill in, or it is left out. For example, the site shows no weight for mulch, because only one source listed one.
- Prices are dated. Price ranges on the cost pages name their source and the month they are dated to, and they are re-checked every quarter.
The site currently draws on 31 sources. The editorial policy explains the standards in full, including how pages are reviewed and corrected.
| Type of source | Sources |
|---|---|
| U.S. government agencies and state transportation departments | 9 |
| University extension services | 9 |
| Manufacturers (product data sheets and guides) | 6 |
| Industry associations | 2 |
| Cost publishers (prices only, always dated) | 3 |
| Suppliers | 2 |
What YardCalculator is not
YardCalculator gives estimates for planning and ordering. It is not engineering advice, and it does not replace your supplier, your contractor or your local building department. A structural slab, a retaining wall or a driveway over poor soil may need a design that no calculator can provide. The disclaimer sets out the limits.
The site has no advertising, no affiliate links and no sponsored content, and it does not sell anything. It does not use analytics or tracking cookies. The privacy policy describes exactly what is and is not collected.
How the content is written
The pages are researched and drafted with the help of AI tools, then checked and approved by Usama Iqbal before they are published. AI is never used as a source: every fact must trace back to a page that was opened and recorded, and the checks described above run on every build whether a sentence was written by a person or drafted with AI help.
Report an error
If you find a number that looks wrong, a broken link or a source that has changed, please say so. Email contact [at] logicodesol [dot] com with the page address and what you think is wrong. Corrections are made as quickly as possible and logged in the update history at the bottom of the page. The contact page has more detail on what to include.
Use the calculators on your own site
Suppliers, contractors and writers can add any calculator to their own pages for free. The embed page has the code; the only credit asked for is a small “Powered by YardCalculator” link.
Find a calculator
Start with the cubic yard calculator, which works for any loose material, or see every page on the site in the HTML sitemap.